
If you are reading this article, it probably mean you own a 2007 Honda and want to learn how to program 2007 Honda accord key. Most modern Honda models have also adopted the long aged keyless entry lock system.
Well the 2007 Honda model is not left out of the trend either, so if you own one then you probably have a key fob too. This key fob helps in locking and unlocking the vehicle from distance, it also adds a layer of security to prevent unauthorized entry.
Key fob is a very important part of the ignition system and can be a problem when lost, misplaced broken or damaged. If you have either misplaced or lost your key fob you will probably need another to continue enjoying the comfort provided by the system.
how to program 2007 Honda accord key 11 steps
Contents
To get a new key fob you would have to visit a dealer’s store which can be very expensive. Another choice which will cost 50% less than the dealership is to call a professional locksmith.
Well if you continue reading this article you will not need to spend any amount other than the one used to buy the new key fob. In this article you will learn how to program 2007 Honda accord key and other Honda model key fob yourself.
Read Also:- Engine Temperature Warning
Follow the guide below to get started
- Prepare Vehicle
ENTER the vehicle and CLOSE and UNLOCK ALL doors.
- Prepare Remote(s)
INSERT the key into the Ignition, HOLD one remote in your left hand with additional remotes close by.
- Enter Programming Mode – Step 1
NOTE:- Every single steps below must and has to be completed within 5 seconds of one another. REPEAT these steps 3 times:
a. TURN the Ignition to the ON (II) position.
b. PRESS and HOLD the LOCK button on the remote for approximately 1 second.
c. TURN the Ignition to the OFF (I) position.
- Enter Programming Mode – Step 2
TURN the Ignition to the ON (II) position.
- Enter Programming Mode – Step 3
PRESS the LOCK button on the same remote. The door locks will cycle LOCK / UNLOCK indicating the vehicle has successfully entered Programming Mode.
- Program Remote
WITHIN 5 seconds, PRESS the LOCK button AGAIN on the same remote. The door locks should cycle again LOCK / UNLOCK indicating the vehicle has successfully PROGRAMMED the remote.
- Program Additional Remotes
To Program any additional remotes to your vehicle, REPEAT Step 6 with each additional remote one after another WITHIN 5 seconds of one another.
- EXIT Programming Mode
Now the programming process is completed but we are not sure if it was successful or not. So to confirm whether or not the process was successful, switch off the ignition and remove the key.
- Trunk Release Programming
After successful programming, if your remote has a TRUNK RELEASE Button — you will need to PRESS and HOLD that button down for 5-10 seconds for that function to begin operation.
- Test Remotes
After you must have successfully programmed and configure the new keyless entry remote, it time to test your work. Now go out of the car and lock all the doors then test the remote from a distance if its working then the process was successful.
- Share There a popular English saying, that says “Sharing is caring” please care for someone in need to day by sharing this article using the social share button below. It might be of great importance to a someone who is facing challenges programming their key fob.
Leave a Reply
You must be logged in to post a comment.