2015 toyota rav4 key fob programming

2015 Toyota RAV4 Key Fob Programming

You are reading this because you want to learn about 2015 Toyota rav4 key fob programming. If you have recently lost your key fob simply want a duplicate for it this article will guide your through easiest process to get it done.

To get a new key fob you would have to visit a dealer’s store which can be  very expensive. Another choice which will cost 50% less than the dealership is to call a professional locksmith.

How to program 2015 Toyota RAV4 key fob

Well if you continue reading this article you will not need to spend any amount other than the one used to buy the new key fob. In this article you will learn how to program 2015 Toyota rav4 key fob and other Toyota models key fob yourself.

Follow the step by step procedure below to get started…

  1. Prepare Vehicle

    ENTER the vehicle and CLOSE and UNLOCK ALL doors.

  2. Prepare Remote(s)

    INSERT the key into the Ignition, HOLD one remote in your left hand with additional remotes close by.

  3. Enter Programming Mode – Step 1

    NOTE:- Every single steps below must and has to be completed within 5 seconds of one another. REPEAT these steps 3 times:

    a. TURN the Ignition to the ON (II) position.

    b. PRESS and HOLD the LOCK button on the remote for approximately 1 second.

    c. TURN the Ignition to the OFF (I) position.

  4. Enter Programming Mode – Step 2

    TURN the Ignition to the ON (II) position.

  5. Enter Programming Mode – Step 3

    PRESS the LOCK button on the same remote. The door locks will cycle LOCK / UNLOCK indicating the vehicle has successfully entered Programming Mode.

  6. Program Remote

    WITHIN 5 seconds, PRESS the LOCK button AGAIN on the same remote. The door locks should cycle again LOCK / UNLOCK indicating the vehicle has successfully PROGRAMMED the remote.

  7. Program Additional Remotes

    To Program any additional remotes to your vehicle, REPEAT Step 6 with each additional remote one after another WITHIN 5 seconds of one another.

  8. EXIT Programming Mode

    Now the programming process is completed but we are not sure if it was successful or not. So to confirm whether or not the process was successful, switch off the ignition and remove the key.

  9. Trunk Release Programming

    After successful programming, if your remote has a TRUNK RELEASE Button — you will need to PRESS and HOLD that button down for 5-10 seconds for that function to begin operation.

  10. Test Remotes

    After you must have successfully programmed and configure the new keyless entry remote, it time to test your work. Now go out of the car  and lock all the doors then test the remote from a distance if its working then the process was successful.

  11. Share                                                                                                                                                                  There a popular English saying, that says “Sharing is caring” please care for someone in need to day by sharing this article using the social share button below. It might be of great importance to a someone who is facing challenges programming their key fob.

Read More

How do you program a 2015 Toyota rav4 key fob?

PRESS and HOLD the LOCK button and hold for 2 seconds. RELEASE. The vehicle will respond by cycling the locks from LOCK to UNLOCK to indicate successful programming of the remote.

How much does it cost to program a key fob?

The cost of replacing a key fob remote can range from $50 to over $100 depending on the automaker and complexity of the design. All key fobs need to be programmed. Some dealerships will do it for free, while others will charge a half-hour to an hour of labor.

2015 toyota rav4 key fob programming

This article is all about 2015 Toyota rav4 key fob programming, it also includes some DIY basic settings and configurations you can do at home.  If you have further questions please ask using the comment section or give us a call today and we will be glad to provide solutions to your problems.

Leave a Comment